The Rocket

The rocket is a 75% version of the Moon Rocket V2 / Kvadratukas. all but three things can be printed from that project.

The parts NOT to print:

  • the inner core
  • the two engine sections

What is extra needed:

  • M12 threaded rod
  • M12 tap, any cheap one, from the Action, Lidl or where ever will do.
  • 1 spools of white PETG
  • 2 spools of red PETG
  • sandpaper, 120, 180, 240 and 320 grid
  • MOTIP plastic primer
  • MOTIP high gloss

Printer settings

I did 5% infill and 3 or 4 wall. You can print the whole rocket, excepts the fins.

You need to paint 100% infill in the slicer, otherwise you will see the fin split. Maybe I will do that, sometime (probably never ;-).

Partial fin
WIP: Partial fin (sorry for the stringing, that is what it did.)

What has changed

The top cone is tapped with M12, the M12 threaded rod will fit there.

Instead of the inner core, print 6 of these:

Progress

After you have printed some parts and 2 of the above cross sections.

Partial core
WIP: Partial core of the rocket

The engine

As the core has been replaced by an M12 threaded rod, the jet engine section needs to be modified. The “engine-section-1” section must have a 12 mm hole, not 10.5 mm and then threaded. That is going to be a pain.

And the final section, “engine-section-2”, must have a 10.5 mm hole drilled into it, so that the M12 threaded rod can be screwed in, thereby completing the rocket.

Sanding an varnishing

After all sections were printed an put together, the sanding stared. Up to and including 320-grit sandpaper, followed by a plastic primer and, finally, a high-gloss or satin-finish varnish – whichever you prefer.

The result

This will result in:

Painted rocket
Painted rocket