The Jet

The jet was created in collaboration with Google Gemini, why? Because I didn’t think I’d be able to model it using FreeCad, and OpenSCAD seemed like a great option to me.

As I was unfamiliar with the OpenSCAD language, it seemed to me that using both AI and OpenSCAD would be a good way to achieve this aim.

Designing

The jet was initially intended to conceal the M12 threaded end. Then came the idea of bringing the jet to life with RGB LED’s.

This suddenly made the design a lot more complicated, for the following reasons:

  • the light needs to be emitted fairly uniformly
  • as the jet is taller than the maximum height my printer can produce, it needs to be split into sections

I thought a standard cylinder was too boring, then I came across a lovely organic jet and had a go at modelling that too, and I have to say I managed to get the AI to produce a result that was pretty much how I wanted it. It wasn’t easy, because the AI does have a mind of its own, after all.

The result is the jet shown below.

The lower section of the jet flairs out to fit the cloud and hide the wires and the M12 nut.

The upper section acts as the connector between the jet motor and the jet, and has been designed so that no direct LED light is visible there.

The central section is designed so that a 16mm aluminium tube can be inserted into it, and the outside of that tube is designed to accommodate LED strips. The cross-brace ensures that everything stays securely in place and should not be visible.

All parameters can be found in the OpenSCAD file.

Printer settings

The printer settings are here to make the transparency as high as possible for white PETG:

  • bed temperature: 70 degree’s
  • nozzle temperature: 245 degrees
  • reduce crossing wall: on
  • seam position: back
  • number of walls: 2

Building

The total height is 43 cm, you may vary it. It is based on what you like an the length of M12 threaded rod you have.

One of the female parts
WIP: one of the female parts just from the bed.

After cleaning it up, it should look like this:

Cleaned up one of the female parts
WIP: cleaned up one of the female parts just from the bed.

The glue all parts together, it would be nice to have a large printer, so you can print it at once, without glue lines.

Jet glued
WIP: jet parts glued together.

After having glued all parts together measure the 16 mm rod and cut it to length, mine was about 43.5 cm and take your time hammering it in and don’t hit too hard.

It’s a shame about the 45 hours of printing if it breaks down now.

almost hammered in
WIP: Alu rod almost hammered in.

Painting

The finishing touches are quite simple:

  • remove the excess glue from the edges
  • sand
  • apply a plastic primer
  • approximately 3 coats of matt varnish